Lil' Lights, Adventures in PCB's, FLIR and high power LED's

                        

                        

After designing the MTV robot I've been slowly tinkering with numerous add ons. I wanted to add some high power LED lights and so I bought some 1 watt white LED's in an SMD package. They offered a lot of light and I'd read that the 1 watt LED didn't need heatsinks to keep the running temperature within the datasheet operational temperature range. 

Testing them on the bench they get hot enough to be uncomfortable on the fingers so I decided that a PCB breakout that enabled them to be easily mounted but also acted as a slight heatsink was desirable. I quickly whipped up a design using the fabulous inkscape plugin SVG2Shenzhen and finished the design off in KiCAD . The PCB has a large pad that interfaces with the LED "slug" and in the PCB pad there are some via's connecting that pad to the large copper flood on the back of the PCB. This flood is under the mask so heat doesn't dissipate massively but I wanted it to just slightly reduce the temperature of the LED. When soldering on the LED I've added a small spot of thermal grease between the LED slug and the PCB pad. Finally I made sure that the M3 mount hole (3.2mm diameter for clearance) wasn't copper plated so that hopefully the heat in the LED and PCB wouldn't wick into mounting bolts etc. 

                        

I got some of the PCB made by the fantastic OSHpark  and mounted up some LED. Driving them at 1 watt is made simpler by using one of the cheap constant current capable DC-DC buck driver boards that are readily available now. They certainly are bright! 

                        

                        

I wanted to test how well everything was working and a friend kindly lent me his very nice FLIR camera. You can see a couple of things below comparing images from both mounted and unmounted LED's, firstly the PCB does indeed reduce the overall temperature a little as compared to the unmounted LED. Rather splendidly you can also see that the PCB mount hole doesn't couple and transfer the heat which is nice to know when bolting them into 3d printed parts. 

                

Above left is the front of an unmounted 1 watt LED. Above Right is the front of an LED mounted on the PCB

Above left is the unmounted LED rear and above right is the rear of the PCB with mounted LED.

                                

Above is a FLIR image of an M3 bolt placed through the mount hole of a PCB mounted LED. 

Get in touch if you are interested in getting any of these boards as I might put some on a tindie shop at some point.